Moreover, this light intensity changes along the y-axis within the width of the monitoring beam, producing a noticeably non-uniform excitation profile. Comparison of absorption measurements at the 802 nm absorption band of membrane-bound RCs in 1 cm and 1 mm path length
cuvettes also reveals such attenuations. However, we have previously shown selleckchem that for a fixed CW excitation intensity the bleaching kinetics is significantly increased with increasing beam diameter, indicating that multiple scattering effects are also in play and can compete with the attenuation effects (Goushcha et al. 2004). For membrane-bound RCs, using a 1 cm path length cuvette, the effective excitation intensity for the membrane-bound RCs is shown to be ~10 times that of the incident excitation intensity due to the scattering inside the sample. Due to the same multiple scattering effects, the overall beam attenuation in the middle of the cuvette with membranes is significantly larger than what is expected due to simple absorption governed by the BLB law. These
two competing effects, beam attenuation and multiple scattering, complicate calculations for the membrane-bound RCs, allowing only a qualitative analysis of the bleaching kinetics in those samples. Fig. 6 Simplified schematic of the cuvette compartment with the CW illumination and monitoring (testing light) configuration. The entire RCs sample is exposed to the CW illumination along the y-axis. The monitoring beam along the x-axis click here illuminates only find more a ~3 mm diameter portion of the CW illuminated sample due to blocking by the
iris diaphragm, resulting in only the hatched region being monitored for the transmittance measurements Discussion For the case of Triton X-100 (see Fig. 2 and Table 2), using light intensities given in units of mW/cm2, a representative value of the light intensity parameter α equal to 0.97 (s−1 cm2/mW) is obtained using Method 1. The rate constants k A = 7.92 s−1 and k B = 1.49 s−1 obtained from the analysis of the bleaching kinetics agree well with the recombination rate constant values from the literature, yet they are slightly different from the corresponding values of 9.1 and 2.23 s−1 obtained from the single flash dark recovery experiments (shown in Table 1). The ratio of 0.78–0.22 of Q B -depleted to Q B -active RCs is in reasonable agreement with the ratio obtained from single flash dark recovery kinetics (0.71–0.29). The α value of 0.98 s−1 cm2/mW obtained using Method 2 is essentially equivalent to that obtained using Method 1. The effective recombination rate constant \( k^\prime_\textrec \), obtained from Method 2 is 4.49 s−1. I-BET151 order Applying this effective recombination rate along with the rate constants from the single flash dark recovery kinetics (\( k_A \approx 9.1\text s^ – 1 \) \( k_B \approx 2.23\,\text s^ – 1 \)) to \( k^\prime_\textrec \) in Eq.